10 Mar My Fire Panel is saying the flame detector is in FIRE, but the detector is not showing a fire – what should I do?
The fire and fault relay could be wired incorrectly. Check against the wiring diagram below. ...
10 Mar What could be causing a false alarm?
False Alarms can be due to the wrong type of Flame Detector being used. As a rough rule of thumb, IR2 and IR3 Flame Detectors should not be used outside unless protected from direct sunlight, which can False Alarm Flame Detectors. To get an activation,...
10 Mar What do I do if my detector’s power LED is not ‘ON’?
Power the unit at ground level and check for a GREEN LED again. It may be that the LED has moved from its position. Check your wiring is connected to power supply and voltage is 24Vdc. If the amber LED illuminates, then the unit is...
10 Mar The Flame Detector won’t go into Fire or Fault when tested. What do I do?
When testing a Talentum Flame Detector, you should only use one of the following tests: 1) Modified Test Torch. The Test Torch with the Blue Filter on the end should not be used as this can give a false pass. There are two modified versions (Infra-Red...
10 Mar How do I wire the Fire Panel?
Click below to download the Talentum Wiring Diagrams. ...
10 Mar How often should I test my flame detector?
We recommend you test your flame detectors at least every 12 months – this can vary depending on site requirements, local laws and regulations and it is your responsibility to know these. Our rule of thumb: if in doubt, test it. Record it....
10 Mar How do I know my flame detector is working?
We offer a Flame Tester unit that works with our entire range of flame detectors. It is advised that when testing your flame detector, you test with the same signal strength and range every time to gauge the effectiveness and functionality more accurately. ...
10 Mar How do you align a flame detector?
Talentum flame detectors do not need to be aligned, simply pointed at a powered unit towards the risk or area being protected. So as long as your risk is in that 90° field of view, a flame will be detected by the unit and go...
10 Mar What is the maximum cable length between the detector and Power Supply?
Using FP200, the maximum distance between the Controller and Detector is 100m, using USA Spec Fireproof cable, the distance is only 80m. ...
10 Mar What type of cable do I need?
In the UK, you should use FP200 Fireproof cable or the Fireproof equivalent in your country. ...