The beam won't go into the Fire or Fault when tested. What do I do?

10 Mar The beam won’t go into the Fire or Fault when tested. What do I do?

Posted at 13:59h in by david-admin 0 Comments

0 Likes

The beam won’t go into the Fire or Fault when tested. What do I do?

First check that Fire and Fault is being displayed by the Beam. If this is not happening, check the way you are testing the Beam. If it is, then check the Fire Resistor and the EOL device is correct. If so, check the Fire and Fault Relays are working and trace the cable back to the Fire Panel.

10 Mar The beam won’t go into the Fire or Fault when tested. What do I do?

The beam won’t go into the Fire or Fault when tested. What do I do?

No Comments

Mission

Vision

Worldwide Clients